CXBX5001

CXBS5001 XBS System Engineering II (Honeywell Live CARE Programming)

Class Type Engineering/Maintenance

System XL5000

Duration 3 days

Class Audience Electricians, electronic systems specialists, and maintenance persons responsible for electrical/electronic installation work at customer sites, Honeywell Authorized System Distributor Installation personnel, and Honeywell systems technicians for XBS or other systems and Programmers/analysts familiar with PC Hardware and Application programs, and Windows.

Additionally the class is highly recommended by CITS for maintenance/service personnel such as Operators/Programmers of XBS systems and/or Maintenance personnel for the XBS Controllers in XBS Central or XBS-i Central HVAC Systems

Offered At Customer site or St Paul

# of Students Minimum 4, Maximum 8

Cost $1259 per person at site, $915 per person St Paul

Pre-requisites CXBX1001

Brief The objective of the course is to expose the student to the full range of capabilities of the Honeywell Live CARE Application. This powerful application is technically a test and checkout tool. It provides powerful tools to check Excel 80, Excel 100, Excel 500, Excel 600 or Excel link controllers for correct control operation.

In this class students learn to monitor hardware and software points from the schematic, control strategy, or switching logic function. They also learn how to ‘fix’ points to prescribed values/states and view user addresses.

For the Excel 10 Zone Manager controllers the students learn how to view alarm history information, diagnostic information, and parameters. This program also shows how to calibrate excel 10 points, display and monitor all physical points associated with the Excel 10 application, and commissioning of Excel 10. The commissioning tool is discussed at length. This tool enables the user to configure the E-bus portion of an Excel 10 and commission the controller with the application, parameters, and linearization tables. This tool also allows the user to configure the Excel-10 ZM controller and router, if there is one.

Objectives Upon completion of the course the student will be able to:

· Initiate Controller Simulation

· Connect to controller

· Initiate/Exit Live Care

· Use on-line Help

· Select a Plant

· Monitor/fix Points

· Change Control Symbol Parameters

· View Control Strategy

· View Switching Logic

· View user Addresses

· View/Modify Excel 10 Information including Diagnostic Information

Topics

· Live CARE Concepts

· Live CARE Start-Up

· Controller Simulation

· Live CARE Initiation

· Typical Procedures/Working with Controller Information

· Control Strategies

· Switching Logics

· User Addresses

· Working with Excel 10 Information

CLASS STATISTICS