Click for Honeywell Automation Parts

CxbX1003             xbs excel 5000 remote hardware/ software installation

Class Type            Installation

System                   XL5000

Duration                3.0 days

Class Audience    Operators of  down-line XBS processors and/or maintenance personnel for the XBS Controllers in XBS Central or XBS-i Central HVAC Systems 

Offered At             Customer site or St Paul

# of Students        Minimum 4,  Maximum 8 

Cost                        $1618 per person at site, $1400 per person St Paul

Pre-requisites    None

Brief                      The basic objective of the course is to prepare the student for the physical installation and wiring of all XBS system remote modules, enhancements and extensions. The course starts with an extensive block diagram of an XBS System and its extensions and enhancements. Students are encouraged to relate the discussion to their own systems if any, and bring up any points that they may need to clarify on. This module of the class is basically a thorough discussion of the entire system and is invaluable to make the students at home with their systems.

                        The course then goes into a full discussion of system documentation interpretation as prepared by Honeywell or other engineers. This knowledge is essential for proper installation of many XBS system modules. This is followed by an extensive discussion and illustration of system wiring and wiring termination for all major XBS system remote modules.

                        The course also discusses system bus wiring and wiring termination. In addition, wiring for all system operator units, printers, remote units, and all service computers is discusses. Unpacking, dismantling, and putting together of critical modules is covered.

Objectives             Upon completion of the course the student will be able to:

·         Describe the hardware components of the XBS Central System 

·         Exhibit an understanding of the function and purpose of each Hardware Module in the XBS system

·         Demonstrate a working knowledge/logical understanding of the XBS Engineering Process

·         Unpack and physically mount all Excel Hardware

·         Perform all wiring terminations for all Excel Hardware Modules

·         Exhibit  knowledge of all wiring terminations from the maintenance point of view

·         Perform all controller Load/Dump and software/firmware install functions

·         Interpret and use site documentation created by Honeywell or other engineers

Topics                   

·         System Hardware/Software Overview

·         Unpacking/mounting of all Excel Controller Modules and other components

·         System Wiring Terminations

·         System Documentation Interpretation 

CLASS STATISTICS                                                        Download Class Description