Click for Honeywell Automation Parts

CITS0921             Intermediate Pneumatic Systems Training 

Class Type            Basic Operation

System                   Mechanical HVAC Systems

Duration                2.5 Days

Class Audience    Operators of Mechanical HVAC Systems, Mechanical Systems  Maintenance Persons, Electronic Technicians responsible for               installing/servicing HVAC Automation Systems

Offered At             Customer site or St Paul

# of Students        Minimum 5, Maximum 8

Cost                        $1095 per person at site, $795 per person St Paul

Pre-requisites      CITS0911

Brief                      The Class starts with an exhaustive overview of a Pneumatic Control System.  The class then immediately gets into a confident discussion of sensor-controller systems.  This is followed by a comprehensive discussion of all major sensor-controller applications such as discharge air control, humidity, mixed air control and resets.  The focus of the class is discussion of popular resets using the RP920 controller.  All models of the RP920 are discussed.  In fact just about every type of sensor-controller system is discussed including the hardware, the settings, applications, operation, calibration, trouble shooting and maintenance.  In particular, information is also provided on the RP908 and other older controllers and control devices.  All pneumatic tools such as relays necessary for each application are also discussed.   The nature and significance of control modes such as proportional, integral and derivative control modes is also elaborated on. 

Every training module is supported by in-depth review questions and hands-on lab exercises.

A major emphasis of the class is maintenance and repair of mechanical pneumatic systems.  The class is quite detailed and busy as it covers a very large set of topics. However, because of CITS exclusive training methodology, the class moves at a relaxed pace without any stress for any student.

Objectives             Upon completion of the course the student will be able to:

·         Analyze a sensor-controller system

·         Configure a sensor-controller system for a single input control system

·         Configure a sensor-controller system for a 2 input control system                    

·         Test/checkout/calibrate a sensor-controller system

·         Perform all Repair and Replacement functions for a sensor-controller system

Topics

·         Pneumatic Control Systems Overview

·         Specialized Pneumatic Hardware such as switches and relays

·         Mixed Control Systems

·         Enthalpy Control Systems

·         Fan Systems Control

·         Discharge Air Control Systems

·         Humidity Control Systems